Adveco ADplus Instantaneous Commercial Water Heaters
- A range of three compact floor-standing commercial instantaneous gas-fired condensing water heaters with built-in storage tank
- Perfect for all water qualities with a 5-year warranty on burner and heat exchangers
Commercial hot water specialist Adveco, announces the Adveco ADplus range of high-power gas-fired condensing water heaters featuring an integrated 120-litre stainless steel water storage tank for instantaneous continuous and on-demand domestic hot water (DHW). The ADplus is available in three variants – 70 kW, 115 kW and 140 kW rated heat output.
“Designed to provide a compact, high capacity and reliable method for delivering instantaneous hot water to a commercial building, ADplus is a tough all-rounder,” said Bill Sinclair, technical director, Adveco. “It is perfect for a wide range of applications – from small instant demands to large-scale continuous DHW needs. With minimal NOX and CO emissions, the ADplus range is an eco-friendly way to serve your building’s DHW system. The rugged construction, supported by Adveco’s in-house warranty engineers, provides real peace of mind for your investment.”
The 115 kW and 140 kW ADplus variants offer two high-quality heat exchangers. Constructed from corrosive-resistant continuous run titanium-stabilised stainless steel, these provide balanced highly efficient operation and built-in redundancy. Heat is provided by the patented Fecralloy premix burner fed by a consistent balanced air/gas ratio at each point of turndown. The high modulation ratio results in high combustion efficiency with ultra-low NOX and CO emissions. A built-in flue back preventer on the combustion circuit prevents possible flue gas recirculation between different exchangers.
The tough, stainless steel 120-litre storage tank is provided with electronic anodic protection and high-quality polyurethane thermal insulation. This enables the ADplus to serve as a semi-storage system, providing always available and instantaneous supply with quick recovery times for continuous provision of DHW. For on-demand needs, ADplus heats what is necessary, with no ignition for smaller withdrawals providing considerable energy savings. When heat is required, the condensing technology provides up to 30% savings in fuel consumption. To reduce acidity build-up caused by the condensing process, the ADplus is equipped with a condensate acidity neutraliser, specifically sized to restore tolerable pH values. With the anti-corrosive construction, ADplus can be used with soft and softened water. For harder water, the recirculating pump regulates the correct water flow according to inlet water hardness helping to prevent the formation of limescale on the heat exchanger surface, ensuring high performance throughout its life cycle.
The extremely compact Adveco ADplus is designed to pass through a standard 65cm wide door for trouble-free installation and offers front access to all inner components for quick, easy maintenance. The integrated cascade controller supports full temperature control and self-check maintenance functions for up to 8 units. The controller accommodates 0-10 input, MODBUS communication, and alarm output for seamless BMS integration.
- High capacity DHW production
- Compact floor-standing arrangement
- High-efficiency pre-mix burner with a five-year warranty
- Extremely high-quality AISI 316Ti heat exchangers with a five-year warranty
- Ultra-low NOX emissions, class 6 appliance at 27 mg/kWh
- CO emissions 19ppm
- High maximum run pressure up to 11 bar
- Flue gas non-return valve for overpressure cascade flue systems
- Standard flue systems using low-cost 110mm diameter PP
- Available using natural gas or LPG
Read more about the Adveco ADplus instantaneous commercial water heater range